Pd350Mhr; Mechanical Height Rod Installation - Cardinal PD150 Owner's Manual

Mechanical Height Rod Installation

The Mechanical Height Rod is packed in its own carton inside the main carton. Before starting
installation, please unpack carefully and remove all plastic wrappings, foam fillers and cardboard
material. You should have the following components:
(1) Detecto Mechanical Height Rod (MHR)
(2) Mounting Brackets
(1) Hardware Pack, containing:
(4) #8-32x1/2" Pan Head Screws (mounting bar to bracket)
(4) #8-32 Hex Nuts
(8) M4x10 PM Screws (bracket to column)
(8) Lock Washers (bracket to column)
(2) #8-32 Hex Head Screw (MHR to mounting bar)
(1) Wrench
#8-32 Pan Head Screw
#8-32 Hex Nut
M4x10 Machine Screw
Lock Washer
1. Referring to Figure No. 17, align a
bracket with the holes near the top of the
mounting bar and install two (2)
#8-32x1/2" Pan Head screws and #8-32
Hex nuts to secure the bracket to the
mounting bar.
2. Next, align the other bracket with the
lower holes in the mounting bar and
install two (2) #8-32x1/2" Pan Head
screws and #8-32 Hex nuts to secure
the bracket to the mounting bar.
3. Install the two (2) #10-32 Hex Head
screws in the threaded holes in the
mounting bar and tighten them with the
included wrench until the hex heads are
1/8" from the bar.

PD350MHR

#8-32 Pan
Head Screw
#8-32 Pan
Head Screw
0044-M380-O1 Rev A ProDoc BFA Series
#10-32 Hex Head Screw
Wrench
Mounting
Bar
Figure No. 17
Mounting
Bracket
#10-32 Hex
Head Screw
#10-32 Hex
Head Screw
Mounting
Bracket
19