Assembly - Cardinal PD150 Owner's Manual

Assembly

Installing the Column
1. Place the scale on a desk or table
2. Connect the connection cable to the preset
cable in the scale base by aligning the tab
on the pin end connector of the connectio
cable with the notch on the socket end of
the preset cable connector and push
together. Next, slide the collar on the pres
cable onto the threads of the connection
cable and screw together. Do not u
finger-tighten only.
3. Align the column with the scale base and
then place the column over the tabs on the
scale base.
NOTE: Center the cable in the column (as
shown in Figure No. 11) when placing the
column over the tabs on the scale base.
4. While holding the column in place on the
scale, carefully lay the scale down with
the column horizontal to the desk or table.
5. Attach the column to the scale base by
inserting four (4) 5x45 machine screws
through the recessed holes in the scale
base into the threaded holes of the
column.
6. Tighten the screws to secure the column
to the scale base.
PD350
Connection
Cable
n
et
se tools,
Column
Tabs on
Scale
Base
M5x45
Machine
Screw
Recessed
Hole in
Base
Threaded
Hole in
Column
0044-M380-O1 Rev A ProDoc BFA Series
Preset
Cable
Figure No. 10
Figure No. 11
Figure No. 12
15