Bmi Measure With Digital Height Rod - Cardinal PD150 Owner's Manual

BMI Measure
with Digital Height Rod
1. Press ON/OFF key.
2. The display will turn on, show all digits, the software version for a few seconds and then a
small o is shown and moves across the display until a stable zero is established.
3. Next, after establishing zero, the scale will show 0.0 on display.
4. Press and hold PRINT/UNITS key to toggle between kilograms and pounds. The kg or lb
annunciator will turn on to show which weighing unit is active.
NOTE: Changing the units between kilograms and pounds will also change the height
measurement between centimeters (cm) and feet/inches ( ' / " ).
5. Make sure the height rod is in the starting position.
IMPORTANT! The digital height rod must be returned to its "starting position"
before every use (the inner sliding tube must be down completely inside the
outer stationary tube) and the headpiece folded flat against the stationary tube.
Otherwise, ----- will be displayed.
6. Patient may now step on scale.
7. Press MODE/ENTER/HEIGHT key.
8. Grasp height rod at hinge pin (see Figure No. 27) and raise it
well above patient's head and then lift headpiece to horizontal
position.
9. Carefully lower height rod until headpiece rests on top of
patient's head.
10. Press MODE/ENTER/HEIGHT key.
11. The display will change to the BFA mode (BFA annunciator will
be flashing)
12. Press the RECALL or
mode (BMI annunciator will be flashing).
13. Press MODE/ENTER/HEIGHT key.
14. While the patient is still standing on the scale, the result will be
shown in sequence: BMI, Weight and Height.
15. Each result will be displayed around 4 seconds, sequentially 3 times. Note that you can
press the RECALL or
While the scale is displaying the result, record patient's BMI, Weight and Height.
16. The scale will then automatically return to the weighing mode.
17. While holding headpiece horizontal, raise height rod well above patient's head.
18. Patient may now step off scale.
19. Return height rod to starting position.
20. To turn scale off, press ON/OFF key. Display will show oFF and turn off.
If the Automatic Shutdown feature has been enable, the scale will turn off after a
pre-defined time of inactivity (no motion on scale).
If the Sleep Mode feature is active and the scale display is showing 0.0 kg/lb (remains at
the center of zero) for a pre-defined time, the display will show SLEEP.
30
OPERATION
STORE keys to select the BMI
STORE keys to rapidly go forward or backward to view the results.
0044-M380-O1 Rev A ProDoc BFA Series
Figure No. 27