Height Measuring Only With Digital Height Rod; Printing Function - Cardinal PD150 Owner's Manual

Height Measuring Only
1. Press ON/OFF key.
2. The display will turn on, show all digits and then the software version will be displayed for a
few seconds.
3. Next, a small o is shown and moves across the display until a stable zero is established.
4. After establishing zero, the scale will show 0.0 on display.
5. Press and hold PRINT/UNITS key to toggle between kilograms and pounds. The kg or lb
annunciator will turn on to show which weighing unit is active.
6. Make sure the height rod is in the starting position.
IMPORTANT! The digital height rod must be returned to its "starting position"
before every use (the inner sliding tube must be down completely inside the
outer stationary tube) and the headpiece folded flat against the stationary tube.
Otherwise, ----- will be displayed.
7. Press the MODE/ENTER HEIGHT key to enter height measuring mode.
8. Patient may now step on scale.
9. Stand straight towards the height rod.
10. Grasp height rod at hinge pin (see Figure No. 26) and raise it
well above patient's head and then lift headpiece to horizontal
position.
11. Carefully lower height rod until headpiece rests on top of
patient's head.
12. Record patient's height.
13. While holding headpiece horizontal, raise height rod well
above patient's head.
14. Patient may now step off scale.
15. Return height rod to starting position.
16. To turn scale off, press ON/OFF key. Display will show oFF
and turn off.
If the Automatic Shutdown feature has been enable, the scale will turn off after a
pre-defined time of inactivity (no motion on scale).
If the Sleep Mode feature is active and the scale display is showing 0.0 kg/lb (remains at
the center of zero) for a pre-defined time, the display will show SLEEP.

Printing Function

Printing a Ticket
When the display is showing the results in BMI or Body Fat and Total Water Estimation
Mode, and if a RS232 printer is connected to the scale, press the PRINT/UNITS key to print
the results to a ticket.
Transferring Data to a Computer
When the display is showing the results in BMI or Body Fat and Total Water Estimation
Mode, and the USB port of the scale is connected to a computer, press the PRINT/UNITS
key to transfer the display data to the computer.
OPERATION
with Digital Height Rod
0044-M380-O1 Rev A ProDoc BFA Series
Figure No. 26
29