Installation; Unpacking; Placement; Level Adjustment - Cardinal Detecto C Series Operation Manual

Unpacking

Before beginning installation of your C Series Digital Counting Scale, make certain the scale
has been received in good condition. Carefully remove the scale from the shipping carton
and inspect it for any evidence of damage (such as exterior dents or scratches) that may
have taken place during shipment. Keep the carton and packing material for return shipment
if it should become necessary. It is the responsibility of the purchaser to file all claims for any
damages or loss incurred during transit.

Placement

Place the scale on a stable, vibration-free level surface away from direct sunlight and from
any rapidly moving air source (heating/cooling vents, fans, etc.). Make certain the power
cord and peripheral cables are routed out of the way of normal traffic.
CAUTION! DO NOT place the scale on any unstable cart, stand or table. The
scale may fall causing injury to the operator, and seriously damage the unit,
or proper operation of the scale may be inhibited.

Level Adjustment

Check to make certain the scale is level. The level indicator is
located at the front of the scale. If the scale is not level (the bubble
will not be centered), loosen the locking ring on all four (4) mounting
feet and adjust them as required to center the bubble and attain a
level scale.

AC Power Adapter

The AC Power Adapter jack is located on the
bottom left side panel in the opening adjacent to
the Power Switch. Insert the plug from the adapter
cord into the jack in the opening of the scale and
then plug the power adapter into the proper
electrical outlet.
Note that the scale also contains the circuitry
necessary to monitor and recharge the battery
and is capable of operating the scale and
recharging the battery simultaneously.
NOTE: It is the responsibility of the customer to
use the proper AC adapter plug for the wall
receptacle.

Remote Scale Interface

The Remote Scale Interface connector socket is
located on the bottom left side panel in the same
opening as the AC Power Adapter jack. Place the
remote scale cable plug on the connector socket
in the scale opening and secure with the two
retaining screws on the scale cable plug.

INSTALLATION

8526-M260-O1 Rev C  C Series Operation
Not Level
Battery
Cover
Remote Scale
AC Adapter Jack
Power Switch
Level
1