Cardinal Detecto MB150 User Manual

Cardinal Detecto MB150 User Manual

Mother-baby scale

Advertisement

Quick Links

Model MB150
Mother-Baby Scale

User Manual

CARDINAL SCALE MFG. CO.
PO BOX 151 • WEBB CITY, MO 64870
8535-M212-O1 Rev A
PH (417) 673-4631 • FAX (417) 673-5001
10/10
www.detectoscale.com
Technical Support: Ph: 866-254-8261 • techsupport@cardet.com
8535-M212-O1 Rev A • MB150
1

Advertisement

Table of Contents
loading

Summary of Contents for Cardinal Detecto MB150

  • Page 1: User Manual

    Model MB150 Mother-Baby Scale User Manual CARDINAL SCALE MFG. CO. PO BOX 151 • WEBB CITY, MO 64870 8535-M212-O1 Rev A PH (417) 673-4631 • FAX (417) 673-5001 10/10 www.detectoscale.com Technical Support: Ph: 866-254-8261 • techsupport@cardet.com 8535-M212-O1 Rev A • MB150...
  • Page 2 8535-M212-O1 Rev A • MB150...
  • Page 3: Table Of Contents

    TABLE OF CONTENTS ......... INTRODUCTION .
  • Page 4 FCC COMPLIANCE STATEMENT WARNING! This equipment generates uses and can radiate radio frequency and if not installed and used in accordance with the instruction manual, may cause interference to radio communications. It has been tested and found to comply with the limits for a Class A computing device pursuant to Subpart J of Part 15 of FCC rules, which are designed to provide reasonable protection against such interference when operated in a commercial environment.
  • Page 5: Introduction

    INTRODUCTION The Model MB150 Mother-Baby Scale is a dual purpose battery-operated scale. The scale has two modes of operation. One mode will weight and compute the BMI (Body Mass Index) of an adult up to 330lb (150kg). The second mode will weight a baby up to 44lb (20kg). The scale is also equipped with a removable baby tray to allow weighing small children.
  • Page 6: Ac Power Adaptor

    AC POWER ADAPTOR 1. Locate AC Power adaptor jack at front of scale. The AC power jack is located on the lower front right of the scale next to the Weight Unit Switch. Weight Unit AC Power Adapter Jack Switch 2.
  • Page 7: Installing/Replacing The Battery

    INSTALLING/REPLACING THE BATTERIES The scale use six "AA" alkaline batteries (not included). You must first obtain and install batteries before operations can begin. Batteries are contained in a battery holder inside the scale. Access is via a removable panel on the bottom of the scale. 1.
  • Page 8: Baby Tray Installation

    BABY TRAY INSTALLATION 1. Install tray from the rear of scale, sliding it to the front of scale (toward the display). Note that arrow on tray should point to front of scale. 2. Turn scale upside down to screw tray and platform together properly. 8535-M212-O1 Rev A •...
  • Page 9 BABY TRAY INSTALLATION, CONT. 3. Hand-tighten the screws to secure the tray to the platform 4. Scale assembly is finished. Turn scale over to begin weighing operations. 8535-M212-O1 Rev A • MB150...
  • Page 10: Key Functions

    KEY FUNCTIONS Weigh – Adult Mode Weigh – Baby Mode 1. On/Off (Baby Mode) 1. Press this key to turn the scale ON. 2. With scale on, press this key to turn the scale OFF. 2. Hold (Baby Mode) 1. Press this key to hold the weight value while weighing. 2.
  • Page 11: Display Annunciators

    DISPLAY ANNUNCIATORS This annunciator is turned on when entering the height for the BMI feature and when displaying the calculated body fat. This annunciator will be turned on and 6! be shown on the display for a few Hold seconds to indicate that the weight from the last weighing operation is being held and the baby, child or adult can be removed from the scale.
  • Page 12: How To Use Bmi Feature

    HOW TO USE THE BMI FEATURE Press the Adult mode On/Off button. Make sure the display is showing . . If not, press the Tare key. Press and hold the Hold/BMI key. The display will momentarily show #! and then change to show the last height. Note that the BMI annunciator will be turned on and that the height value will be flashing Enter the new height by pressing the ( + ) key to increase the value or by pressing the ( –...
  • Page 13: Error Messages

    ERROR MESSAGES Low Battery This message indicates that the battery should be replaced soon. If the battery voltage drops too low, continued use with a low battery can affect weighing accuracy. Remove the old battery and replace with a new battery for operation. Over Load The load is over the scale capacity.
  • Page 14 8535-M212-O1 Rev A • MB150...
  • Page 15 8535-M212-O1 Rev A • MB150...
  • Page 16 8535-M212-O1 Rev A • MB150...

Table of Contents