Setting The Auto Continue Recovery Time - Kyocera Mita FS-C8008DN Operation Manual

3.13.9 Setting the Auto Continue Recovery Time

Follow the procedure given below to change the recovery time for Auto Continue.
1 1 1 1
Press the MENU key.
2 2 2 2
Press the or
Others
3 3 3 3
Press the key.
4 4 4 4
Press the or
>Auto Continue >
Mode On
5 5 5 5
Press the key and display >> Auto Continue Timer. The default setting is
30 seconds.
>>Auto Continue
Timer 030sec.
6 6 6 6
Press the ENTER key. A blinking cursor (_) appears.
>>Auto Continue
Timer 030sec.
7 7 7 7
Press the or
the desired time. The time must be set between 000 and 495 seconds, in 5-second
increments. If set to 000, printing will be continued immediately without any time
interval. You can use the
8 8 8 8
Display the desired time and press the ENTER key.
9 9 9 9
Press the MENU key. The display returns to Ready.
key repeatedly until Others > appears.
>
key repeatedly until Auto Continue Mode > appears.
key to increase or decrease the value at the blinking cursor and set
and keys to move the cursor right and left.
3-97
3.13 Other Modes