Installation Procedure; Standalone Switch Module Back Panel - Lucent Technologies DEFINITY Administrator's Manual

Installation
Figure 3-1. Standalone Switch Module Back Panel
In addition to the back panel connections, a three-color light-
emitting diode (LED) is visible through the top of each unit and
provides information about the status of the equipment.

Installation Procedure

Installing the Standalone Switch Module involves wiring the module
to the DEFINITY ECS and connecting the power cord. You will
need the applicable wiring to connect the Switch Module to the
DEFINITY ECS. See the DEFINITY® Communications System
Generic 3, Installation for Single-Carrier Cabinets manual,
document #555-230-894, comcode #107595423, for complete
installation requirements.
Following installation, administer the line and station ports that use
the Standalone Switch Module according to the instructions in
DEFINITY® Communications System Generic 3 Implementation
Guide, Issue 1, document #555-230-655.
Follow these steps to install the Switch Module:
1. Ensure that the module has the proper DIP switch configuration
(see Table 3-1).
3-4
Issue 3 July 1997