Lucent Technologies DEFINITY Administrator's Manual page 33

Introduction
Customer-Supplied
Equipment
NOTE:
DEFINITY telephones are not supplied with either the Switch
Module or the Remote Module and must be ordered separately.
Contact your Lucent Technologies representative for
information. Remote Modules are also ordered and shipped
separately. For new DEFINITY Extender systems that use
Standalone Switch Modules, you should order at least one
Remote Module to be used in the initial programming of
passwords.
You must supply the following for installation:
DEFINITY ECS two-wire, 16-port TN-2181 circuit pack
Any additional DEFINITY ECS circuit packs needed (see the
DEFINITY® Communications System Generic 3, Installation for
Single-Carrier Cabinets manual, document #555-230-894,
comcode #107595423, for further information).
An adapter to convert to 120 vac if you are connecting the
Standalone Switch Module or the Multi-Mount Rack to a 240-
vac outlet.
Power and central office line suppressor. Lucent Technologies
recommends the 147C AC/CO Line Surge Protector (#8310-
006). Contact your Lucent Technologies representative for
ordering instructions.
A 50-pin Amphenol connector of proper length for the Multi-
Mount Rack
Up to 12 Rack-Mount Switch Modules for each Multi-Mount
Rack that has been ordered
Issue 3 July 1997
1-5