Lucent Technologies DEFINITY Administrator's Manual page 51

Password Programming
Follow these steps to program passwords for the Remote Module
users:
1. After you have entered your password and the modules are
connected, press the Hold button on the display telephone four
times until the following screen appears:
3
2. Press
3
3. Press
NOTE:
If the Software Version screen appears, make sure that DIP switch
3 on the Remote Module is set to ON. If it is necessary to move the
DIP switch, you must power off and on the Remote Module after
you move the DIP switch.
2
4. Press
the old password (a * will appear for each digit entered).
5. Enter the system administrator password (beginning with 00.)
2-10
Issue 3 July 1997
and the following screen appears:
and the following screen appears:
to change a password. You will be prompted to enter