Lucent Technologies DEFINITY Administrator's Manual page 80

Installation
!
CAUTION:
Connecting the Remote Module to the PBX can result in
damage to the module. Prior to installation, check that you
have the Standalone Switch Module by looking at the name
on the top of the unit.
2. Connect the wiring between the DEFINITY analog circuit pack
(the 8-port TN742 or the 16-port TN746) or a dedicated central
office line and the LINE jack of the Standalone Switch module
at the on-premise location. See the DEFINITY®
Communications System Generic 3, Installation for Single-
Carrier Cabinets manual for complete instructions.
3. If you have not already done so while programming passwords,
connect the Standalone Switch Module PORT jack to the 2-
wire, 16-port TN2181 circuit pack on the DEFINITY ECS. See
the DEFINITY® Communications System Generic 3, Installation
for Single-Carrier Cabinets manual for complete instructions.
!
CAUTION
Do not plug the line cord into the PORT jack of the
Standalone Switch Module. Damage to circuits may result.
4. Connect the AC adapter provided with your system to the
Standalone Switch Module. Plug the adapter into a standard
120-vac electrical outlet.
3-6
Issue 3 July 1997
: