3Com Switch 7700 Configuration Manual page 357

Perform the following configuration in system view.
Table 49 Setting SNMP System Information
Operation
Set SNMP system information
Restore the default SNMP system information
of the Ethernet switch
By default, syslocation is specified as "Marlborough MA".
Setting the Engine ID of a Local or Remote Device
Use the following commands to set the engine ID of a local or remote device.
Perform the following configuration in system view.
Table 50 Setting the Engine ID of a Local or Remote Device
Operation
Set the engine ID of the device
Restore the default engine ID of the device.
By default, the engine ID is expressed as enterprise No. + device information. The
device information can be IP address, MAC address, or user-defined text.
Setting and Deleting an SNMP Group
Use the following commands to set or delete an SNMP group.
Perform the following configuration in system view.
Table 51 Setting and Deleting an SNMP Group
Operation
Setting an SNMP group
Deleting an SNMP group
The authentication parameter specifies that the packet is authenticated without
encryption. This parameter is supported only in SNMP V3.
The privacy parameter specifies that the packet is authenticated and encrypted.
This parameter is supported only in SNMP V3.
Command
snmp-agent sys-info { contact sysContact |
location syslocation | version { { v1 | v2c | v3
] * | all } }
undo snmp-agent sys-info [ { contact |
location }* | version { { v1 | v2c | v3 ] * | all }
]
Command
snmp-agent local-engineid engineid
undo snmp-agent local-engineid engineid
Command
snmp-agent group group-name { v1 | v2c } [
read-view read-view ] [ write-view
write-view ] [ notify-view notify-view ] [ acl
acl-list ]
snmp-agent group group-name v3 [
authentication | privacy ] [ read-view
read-view ] [ write-view write-view ] [
notify-view notify-view ] [ acl acl-list ]
undo snmp-agent group group-name { v1 |
v2c }
undo snmp-agent group group-name v3 [
authentication | privacy ]
SNMP 349