3Com Switch 7700 Configuration Manual page 58

50 C 3: VLAN C
HAPTER ONFIGURATION
Example: VLAN
Configuration
Creating and Deleting a VLAN Protocol Type
You can use the following command to create or delete a VLAN protocol type.
Perform the following configuration in VLAN view.
Table 9 Creating and Deleting a VLAN Protocol Type
Operation
Create a VLAN protocol type
Delete an existing VLAN protocol type
Creating and Deleting the Association Between a Port and a
Protocol-Based VLAN
Perform the following configuration in Ethernet port view.
Table 10 Creating and Deleting the Association Between a Port and a Protocol-Based
VLAN
Operation
Create the association between a port and a
protocol-based VLAN
Delete the association between a port and a
protocol-based VLAN
Note that the port must be a hybrid port and it must belong to that
protocol-based VLAN.
Create VLAN2 and VLAN3. Add Ethernet1/0/1 and Ethernet1/0/2 to VLAN2. Add
Ethernet1/0/3 and Ethernet1/0/4 to VLAN3.
Figure 2 VLAN Configuration Example
E1/0/1 E1/0/2
VLAN2
1 Create VLAN 2 and enter its view.
[SW7700] vlan 2
2 Add Ethernet1/0/1 and Ethernet1/0/2 to VLAN2.
[SW7700-vlan2] port ethernet1/0/1 to ethernet1/0/2
3 Create VLAN 3 and enters its view.
Command
protocol-vlan [ protocol-index ] { ip [
ip_address [ net_mask ] ] | ipx { ethernetii I
llc I raw I snap } | at | mode { ethernetii I llc
I snap } }
undo protocol vlan protocol {
protocol_index [ to protocol_end ] | all }
Command
port hybrid protocol-vlan vlan-protocol_list
undo port hybrid protocol-vlan
vlan-protocol_list
Switch
E1/0/3 E1/0/4
VLAN3