3Com Switch 7700 Configuration Manual page 22

14 C 1: S A
HAPTER YSTEM CCESS
Perform the following configurations in user interface (AUX user interface only)
view.
Table 3 Configure the Attributes of the AUX (Console) Port
Operation
Configure the transmission speed on AUX
(Console) port. By default, the transmission
speed is 9600bps
Restore the default transmission speed on
AUX (Console) port
Configure the flow control on AUX (Console)
port. By default, no flow control is performed
on the AUX (Console) port
Restore the default flow control mode on AUX
(Console) port
Configure parity mode on the AUX (Console)
port. By default, there is no parity bit on the
AUX (Console) port
Restore the default parity mode
Configure the stop bit of AUX (Console) port.
By default, AUX (Console) port supports 1
stop bit
Restore the default stop bit of AUX (Console)
port
Configure the data bit of AUX (Console) port.
By default, AUX (Console) port supports 8
data bits.
Restore the default data bit of AUX (Console)
port
Configuring the Terminal Attributes
The following commands can be used for configuring the terminal attributes,
including enabling/disabling terminal service, disconnection upon timeout,
lockable user interface, configuring terminal screen length and history command
buffer size.
Perform the following configuration in user interface view. Perform the lock
command in user view.
Enabling and Disabling Terminal Service After the terminal service is
disabled on a user interface, you cannot log in to the Switch 7700 through the
user interface. However, if a user logged in through the user interface before
disabling the terminal service, the user can continue operation. After the user logs
out, the user cannot log in again. In this case, the user can log in to the Switch
through the user interface only when the terminal service is enabled again. Use
the commands described in Table 4 to enable or disable terminal service.
Table 4 Enabling and Disabling Terminal Service
Operation
Enable terminal service
Disable terminal service
Command
speed speed-value
undo speed
flow-control { hardware | none |
software }
undo flow-control
parity { even | mark | none | odd | space }
undo parity
stopbits { 1 | 1.5 | 2 }
undo stopbits
databits { 7 | 8 }
undo databits
Command
shell
undo shell