3Com Switch 7700 Configuration Manual page 81

Assigning IPX Network Numbers to VLAN Interfaces
To enable IPX on a VLAN interface after it is enabled globally, you must assign a
network number to the VLAN interface. One VLAN interface can have only one
network number.
Perform the following configuration in VLAN interface view.
Assigning an IPX Network Number to VLAN Interface
Table 18
Operation
Assign an IPX network number to the VLAN
interface
Delete the IPX network number of the VLAN
interface
By default, no network number is assigned to the VLAN interface. In other words,
IPX is disabled on all the VLAN interface even after it is enabled globally.
Note that deleting the IPX network number of the VLAN interface also deletes the
IPX configuration and routing information on the interface.
Configuring IPX Routing
After you have enabled IPX and assigned the IPX network number to a VLAN
interface, you can use the following sections to configure IPX routing.
Configuring IPX Static Routes
■
Configuring an IPX Route Limit
■
Configuring the Maximum Number of Dynamic Routes to the Same
■
Destination
Configuring the Number of the Equivalent Routes to the Same Destination
■
Configuring the Update Interval of IPX RIP
■
Configuring the Aging Period of IPX RIP
■
Configuring the Size of IPX RIP Update Packets
■
Configuring the IPX Packet Forwarding Delay on a VLAN Interface
■
Configuring IPX RIP to Import Static Routes
■
Configuring IPX Static Routes Perform the following configuration in system
view.
Configuring an IPX Static Route
Table 19
Operation
Configure an IPX static route
Delete an IPX static route
The IPX static routes with the destination network number of 0xFFFFFFFE are
default routes.
IPX Configuration
Command
ipx network network-number
undo ipx network
Command
ipx route-static network network.node [
preference value ] [ tick ticks hop hops ]
undo ipx route-static { network [
network.node ] | all }
73