3Com Switch 7700 Configuration Manual page 358

350 C 11: S
HAPTER YSTEM
M
ANAGEMENT
Setting the Source Address of the Trap
Use the following commands to set or remove the source address of the trap.
Perform the following configuration in system view.
Table 52 Setting the Source Address of the Trap
Operation
Set the Source Address of Trap
Remove the source address of trap
Adding and Deleting a User to or from an SNMP Group
Use the following commands to add or delete a user to or from an SNMP group.
Perform the following configuration in system view.
Table 53 Adding and Deleting a User to or from an SNMP Group
Operation
Add a user to an SNMP group
Delete a user from an SNMP group
The authentication-mode parameter specifies the use of authentication. The
privacy-mode parameter specifies the use of authentication and encryption. This
parameter is supported only in SNMP V3.
For details, see the Switch 7700 Command Reference Guide.
Creating and Updating View Information or Deleting a View
Use the following commands to create, update the information of views, or delete
a view.
Perform the following configuration in system view.
Table 54 Creating and Updating View Information or Deleting a View
Operation
Create or update view information
Delete a view
Setting the Size of an SNMP Packet Sent or Received by an Agent
Use the following commands to set the size of SNMP packet sent or received by an
agent.
Command
snmp-agent trap source interface-name
interface-num
undo snmp-agent trap source
Command
snmp-agent usm-user { v1 | v2c } username
groupname [ acl acl-list ]
snmp-agent usm-user v3 username
groupname [ authentication-mod { md5 |
sha } auth_password [ privacy-mod { des56
priv_password } ] ] acl acl-list
undo snmp-agent usm-user { v1 | v2c }
username groupname
undo snmp-agent usm-user v3 username
groupname { local | engineid engine-id }
Command
snmp-agent mib-view { included |
excluded } view-name oid-tree
undo snmp-agent mib-view view-name