3Com Switch 7700 Configuration Manual page 315

the server responds or discards the messages. Use this command to set the
maximum retransmission times.
Perform the following configurations in RADIUS server group view.
Table 29 Set the Maximum Retransmitting Times of Stopping Accounting Request
Operation
Set the maximum retransmitting times of stop
accounting request
Restore the maximum retransmitting times of
stop accounting request to the default value
By default, the stop accounting request can be retransmitted for up to 500 times.
Setting the Supported Type of RADIUS Server
The Switch 7700 supports the standard RADIUS protocol and the extended
RADIUS service platforms, such as IP Hotel, and Portal.
Perform the following configurations in RADIUS server group view.
Table 30
Setting the Supported Type of RADIUS Server
Operation
Setting the supported type of RADIUS Server
Restore the supported type of RADIUS Server
to the default setting
By default, the RADIUS server type is standard.
Setting RADIUS Server State
For the primary and secondary servers, if the primary server is disconnected from
NAS because of a fault, NAS will automatically turn to exchange packets with the
secondary server. However, after the primary server recovers, NAS does not resume
communication with the primary server immediately, instead, it continues
communicating with the secondary server. When the secondary server fails to
communicate, NAS returns to the primary server. The following commands can be
used to set the primary server to be active manually, so that NAS can
communicate with it immediately after troubleshooting.
When the primary and second servers are both active or block, NAS sends the
packets to the primary server only.
Perform the following configurations in RADIUS server group view.
Table 31 Set RADIUS Server State
Operation
Set the state of primary RADIUS server
Set the state of second RADIUS server
By default, the state of each server in RADIUS server group is active.
Configuring the AAA and RADIUS Protocols
Command
retry stop-accounting retry-times
undo retry stop-accounting
Command
server-type {3ComType | iphotel | portal |
standard}
undo server-type
Command
state primary {accounting |
authentication} {block | active}
state secondary{accounting |
authentication} {block | active}
307