Connecting The Foot Control Cord; Connect The Power Cord And Foot Control; Lower The Feed Teeth - Husqvarna Viking Tribute 140C User Manual

CONNECTING THE FOOT CONTROL CORD

Among the accessories you will nd the foot control cord
and the power cord. Connecting the foot control cord to
the foot control is only necessary the very rst time you are
going to use the machine.
1. Take out the foot control cord. Turn the foot control
over. Connect the cord to the socket inside the space of
the foot control.
2. Push rmly to make sure it is properly connected.
3. Lay the cord in the slot on the underside of the foot
control.
CONNECT THE POWER CORD
AND FOOT CONTROL
On the underside of the machine you will nd information
about the power supply voltage (V) and the frequency (Hz).
Before plugging in the foot control, check to ensure that it is of type
"FR5" (see underside of foot control).
1. Connect the foot control cord to the front socket on the
bottom right side of the machine.
2. Connect the power cord to the rear socket on the
bottom right side of the machine.
3. Press the ON/OFF switch to ON to turn on power and
light.
For the USA and Canada
This sewing machine has a polarized plug (one blade
wider than the other). To reduce the risk of electric
shock, this plug is intended to t in a polarized outlet
only one way. If the plug does not t fully in the outlet,
reverse the plug. If it still does not t, contact a quali ed
electrician to install the proper outlet. Do not modify
the plug in any way.

LOWER THE FEED TEETH

The feed teeth are lowered when you move the switch on
the front of the free arm to the right. Move the switch
to the left if you wish to raise the feed teeth. The feed
teeth will raise as you begin to sew. The feed teeth should
be lowered when sewing on buttons and for free motion
sewing.
8 – Get ting Ready to Sew
3 1 2