Loading Single Sheets; Loading The Paper Without Optional Accessories - Star Micronics XB24-200 User Manual

LOADING SINGLE SHEETS
This section will take you through the procedures for loading single sheets
of paper.
Loading the paper without optional accessories
If you are using the optional Automatic Sheet Feeder, refer to next section.
1. Place the paper guide in position by inserting the tabs, located on the
bottom of the assembly, into the slots on the rear cover of the printer.
Paper guide
F/gum 4-72 Mounti~ the paper guide for single sheets.
2. Adjust the paper guides to match the size of the paper you will be using.
Remember that printing will start some distance from the left-hand edge
of the carriage.
3. Turn on the power using the switch located at the front of the printer. The
printer will beep, indicating that there is no paper in position for printing.
The "PAPER OUT
message will also flash to confirm this.
4. Make sure that the release lever is at front position.
If fanfold paper is already mounted in the printer, press the
I"'?ZZE'T button to park the paper in the off-line state, then move the
release lever forward.
-
-
-
-
-
-
-
-
-
-