Forms Parameters - Star Micronics XB24-200 User Manual

Forms parameters
The Forms parameters are assigned to Bank "F', including these functions:
l
Auto Line Feed
If you set this switch OFF, a separate line-feed code is required from your
computer to obtain a line feed.
If you set this switch ON, the printer performs both a carriage return and
line feed each time it receives a carriage-return code.
Most computer systems send a line feed code, or both a carriage return and
line feed, at the end of each line, so this switch should be left OFF.
If you get double line spacing when you expect single spacing, or if lines
overprint each other, try changing the setting of this switch.
l
Auto Carriage Return
-
-
If you set this switch OFF, a separate carriage-return code is required from
your computer to return to the left margin.
If you set this switch ON, the printer performs both a carriage return and
line feed each time it receives a line-feed code.
l
Tear-Off function
-
-
You can select the Tear Off function with this switch ON.
When using fanfold paper, the Tear Off function allows you to tear off one
sheet of paper without fully advancing the following sheet.
l
Skip-over-perforation
You can select the Skip-over-perforation with this switch ON.
It is recommended to skip close to the perforation of fanfold forms to get
good print quality.
If you cannot set this function with your software, set this switch ON. The
printer automatically skips the perforations.
l
Page length
You can set a different page length to accommodate your paper with this
switch.
-
-.
-
-
-
-
--
68