Star Micronics XB24-200 User Manual page 67

Following table shows the default settings at the factory.
Display Message Meaning
Al EMULATION STD
Standard emulation mode is selected.
A2 RAM BUFFER
RAM is used as the print buffer.
A3 QUIET OFF
Quiet mode is cancelled.
A4 GRAPH DIR BI
Bi-directional printing is selected for graphics.
A5 AUTO-ONLINE Y 1 Auto on-line mode is selected.
Bl MODE LQ/SLQ
LQ/SLQ mode is selected.
B2 LD ROMAN
Roman font is selected for LQ/SLQ mode.
Cl STD GRAPH
Graphic set is selected for Standard character set.
C2 IBM I
BM12
Set #2 is selected for IBM character set.
C3 ZERO NORMAL
Normal zero character is selected.
C4 CODEPAGE #437
Code Page #437 (U.S.A.) is selected.
C5 COUNTRY USA
U.S.A. character set is selected.
Dl ITALIC
0 F F
1 Italic print mode is cancelled.
I
D2 PITCH 10
Pica pitch (10 CPI) is selected.
El MULTIPART OFF
Multi-part mode is cancelled.
E2 PAPER-OUT ON
Paper-out detector is enabled.
E3 ASF
0 F F
Optional ASF is not installed.
E4 T.MGN-CUT l/6
Top margin for cut forms is set to l/6 inch.
E5 T.MGN-ASF l/6
Top margin for ASF is set to l/6 inch.
E6 T.MGN-TRA l/6
Top margin for fanfold forms is set to l/6 inch.
E7 BOTTM MGN l/6
Bottom margin is set to l/6 inch.
E8 L.P.I.
6
6
lines can be printed on one inch.
Fl AUTO-LF
OFF
LF must be from host.
F2 AUTO-CR ON
Auto CR with LF.
F3 TEAR-OFF OFF
Tear-off function is disabled.
F4 SK I P - PER F 0 F F
1 Skip-over-perforation is disabled.
I
F5 PAGE-LGTH 11
Page length is set to 11 inches.
Gl STROBE NORMAL
Set the normal interface timing.
G2
EDS CURRENT
Set the current EDS settings.