Star Micronics XB24-200 User Manual page 50

8. Adjust the right paper guide to accommodate the width of the paper.
The guides should be adjusted to restrict the amount of horizontal play
while allowing the paper to slide up and down freely between the two
paper guides. The ideal distance between paper ream and paper guides is
0.25 mm (0.01") on both sides at the narrowest part of the paper guides.
9. Fan the paper stack and square it off properly before inserting it into the
Automatic Sheet Feeder.
-
Flgun 417. FM the paper before inserting into the ASF.
10. Insert the paper stack into the Automatic Sheet Feeder.
The stack should not be more than 15 mm (5/V) equivalent to 150 sheets
of 20 lb paper.
If necessary, remove some sheets. The ASF may not perform satisfac-
torily if it is overloaded.
-
.~
11. When you am using Single-Bin ASF, push the paper loading lever toward
the back.
In case of the Dual-Bin ASF, push both pressure bar levers toward the
back to "FEED"
-
L
Figurr 418. Push the paper loading lever or pressure bar levers to hold lhe paper stack.
42
-
-