Connect The Printer's Power Cord; Loading Single Sheets; Mount The Paper Guide - Star Micronics NX-1000 User Manual

Figure 1-6. Connecting the interface cable
Connect the printer's power cord.
Check that the printer's power switch (located at the left front) is OFF.
Then plug the printer's power cord into an AC wall outlet.
Never plug or unplug the power cord while the printer is turned on.
LOADING SINGLE SHEETS
This section will take you through the procedures for loading single
sheets of paper.
If you are using the optional automatic sheet feeder (ASF), read the
ASF instruction booklet.
Mount the paper guide
-
The paper guide tits into the two holes on top of the rear cover. Mount
the guide and raise it to the upright position.
6