Using The Cli To Configure Snmp; Cli Commands For Snmp - Enterasys RoamAbout RBT-4102 Configuration Manual

SNMP

Using the CLI to Configure SNMP

The access point includes an on‐board agent that supports SNMP versions 1, 2c, and 3. Access to
the on‐board agent using SNMP v1 and v2c is controlled by community strings. To communicate
with the access point, a management station must first submit a valid community string for
authentication.
Refer to the RoamAbout RBT‐4102 Wireless Access Point Command Line Interface Reference Guide, for a
complete list of SNMP commands.

CLI Commands for SNMP

Use the snmp‐server enable server command from the global configuration mode to enable
SNMP. You can use the snmp‐server v1 enable command to prevent access from SNMPv1 clients.
To set read/write and read‐only community names, use the snmp‐server community command.
The snmp‐server host command defines trap receiver hosts and the snmp‐server trap command
enables or disables specific traps.
Examples
RoamAbout 4102#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 4102(config)#snmp-server enable server
RoamAbout 4102(config)#snmp-server v1 disable
RoamAbout 4102(config)#snmp-server community alpha rw
RoamAbout 4102(config)#snmp-server community beta ro
RoamAbout 4102(config)#snmp-server host 1 192.168.1.9 alpha
RoamAbout 4102(config)#snmp-server trap dot11StationAssociation
RoamAbout 4102(config)#
To view the current SNMP settings, use the show snmp command.
RoamAbout 4102#show snmp
SNMP Information
==============================================
Service State
Community (ro)
Community (rw)
EngineId
EngineBoots:1
Trap Destinations:
1:
2:
3:
4:
dot11StationAssociation
dot11StationReAssociation
dot11WirelessSTPDetection
dot1xAuthNotInitiated
4-34 Advanced Configuration
:80:00:07:e5:80:00:00:2e:62:00:00:00:18
192.168.1.9, Community: *****, State: Enabled
0.0.0.0, Community: *****, State: Disabled
0.0.0.0, Community: *****, State: Disabled
0.0.0.0, Community: *****, State: Disabled
dot11InterfaceAFail
dot1xMacAddrAuthFail
iappContextDataSent
iappStationRoamedTo
: Enable
: *****
: *****
Enabled dot11InterfaceGFail
Enabled dot11StationAuthentication
Enabled dot11StationRequestFail
Enabled
Enabled
Enabled dot1xMacAddrAuthSuccess
Enabled iappStationRoamedFrom
Enabled localMacAddrAuthFail
Enabled
Enabled
Enabled
dot1xAuthFail Enabled
dot1xAuthSuccess Enabled
Enabled
Enabled
Enabled