Using Web Management To Configure Radius - Enterasys RoamAbout RBT-4102 Configuration Manual

Using Web Management to Configure RADIUS

Select RADIUS from the menu.
• Primary Radius Server Setup configures the following settings to use RADIUS authentication on
the access point:
– IP Address/Server Name specifies the IP address or host name of the RADIUS server. The IP
address must be an IP Version 4 address.
– Port Number is the UDP port number used by the RADIUS server for authentication. This
value must match the configuration of your primary RADIUS authentication server.
Range: 1024‐65535; Default: 1812
– Key is the shared text string used to encrypt messages between the access point and the
RADIUS server. Be sure that the same text string is specified on the RADIUS server. Do
not use blank spaces in the string. Maximum length: 255 characters
– Timeout (seconds) is the number of seconds the access point waits for a reply from the
RADIUS server before re‐sending a request. Range: 1‐60 seconds; Default: 5
– Retransmit attempts is the number of times the access point tries to re‐send a request to the
RADIUS server before authentication fails. Range: 1‐30; Default: 3
Note: For the Timeout and Retransmit attempts fields, accept the default values unless you
experience problems connecting to the RADIUS server over the network.
RoamAbout RBT-4102 Wireless Access Point Configuration Guide 4-11
RADIUS