Using The Cli To Configure Radius Mac Authentication - Enterasys RoamAbout RBT-4102 Configuration Manual

Security

Using the CLI to Configure RADIUS MAC Authentication

Use the mac‐authentication server command from the Interface Wireless or Interface Wireless:
VAP configuration modes to enable remote MAC authentication. Set the timeout value for re‐
authentication using the mac‐authentication session‐timeout command. Specify a password for
the AP to send to the RADIUS server for MAC authentication using the mac‐authentication
password command. Be sure to also configure connection settings for the RADIUS server (not
shown in the following example).
Examples
RoamAbout 4102#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 4102(config)#interface wireless a
Enter Wireless configuration commands, one per line.
RoamAbout 4102(if-wireless a)#mac-authentication server remote
RoamAbout 4102(if-wireless a)#mac-authentication session-timeout 300
RoamAbout 4102(if-wireless a)#mac-authentication password *****
RoamAbout 4102(if-wireless a)#vap 6
RoamAbout 4102(if-wireless a: VAP[6])#mac-authentication server remote
RoamAbout 4102(if-wireless a: VAP[6])#mac-authentication session-timeout 300
RoamAbout 4102(if-wireless a: VAP[6])#mac-authentication password *****
RoamAbout 4102(if-wireless a: VAP[6])#exit
RoamAbout 4102#
4-86 Advanced Configuration