Enterasys RoamAbout RBT-4102 Configuration Manual page 29

RICO, QA-QATAR, RO-ROMANIA, RU-RUSSIA, SA-SAUDI ARABIA, SG-SINGAPORE,
SK-SLOVAK REPUBLIC, SI-SLOVENIA, ZA-SOUTH AFRICA, ES-SPAIN, SE-SWEDEN,
CH-SWITZERLAND, SY-SYRIA, TW-TAIWAN, TH-THAILAND, TT-TRINIDAD & TOBAGO,
TN-TUNISIA, TR-TURKEY, UA-UKRAINE, AE-UNITED ARAB EMIRATES, GB-UNITED
KINGDOM, UY-URUGUAY, UZ-UZBEKISTAN, VE-VENEZUELA, VN-VIETNAM, YE-YEMEN,
ZW-ZIMBABWE
b. Determine the code for your country, and then type country followed by your country
code (for example, country SG for Singapore).
c. Reboot the RoamAbout RBT‐4102.
RoamAbout 4102#country SG
Please reset the AP to make the country code change effective
RoamAbout 4102#reset board
Reboot system now? <y/n>: y
3. If your access point uses a DHCP assigned IP address, go to Step
username and password.
Otherwise, disable DHCP for this access point as follows:
a. Type configure to enter configuration mode.
b. Type interface ethernet to access the Ethernet interface configuration mode.
RoamAbout 4102#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 4102(config)#interface ethernet
Enter Ethernet configuration commands, one per line.
RoamAbout 4102(if-ethernet)#
c. Enter no ip dhcp to disable DHCP.
RoamAbout 4102(if-ethernet)#no ip dhcp
DHCP client state has changed. Please reset AP for change to take effect.
RoamAbout 4102(if-ethernet)#exit
RoamAbout 4102#reset board
Reboot system now? <y/n>: y
Username: admin
Password:********
RoamAbout 4102#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 4102(config)#interface ethernet
Enter Ethernet configuration commands, one per line.
RoamAbout 4102(if-ethernet)#
d. Set the IP Address. Type ip address ip‐address netmask gateway, where ip‐address is the
access point's IP address, netmask is the network mask for the network, and gateway is
the default gateway router. Check with your system administrator to obtain an IP address
that is compatible with your network.
RoamAbout 4102(if-ethernet)#ip address ip-address netmask gateway
RoamAbout 4102(if-ethernet)#end
RoamAbout 4102(config)#
After configuring the access point's IP parameters, you can access the management
interface from anywhere within the attached network. The command line interface can
also be accessed using Telnet from any computer attached to the network.
e. Go to Step 4.
RoamAbout RBT-4102 Wireless Access Point Configuration Guide 3-3
Initial Setup Using the CLI
4 to change the default