Cli Commands For Filtering - Enterasys RoamAbout RBT-4102 Configuration Manual

CLI Commands for Filtering

Use the filter ibss‐relay command from the global configuration to set the mode for wireless‐to‐
wireless communications through the access point. Use the filter wireless‐ap‐manage command
to restrict management access from wireless clients. Use the iapp or no iapp commands to enable
or disable clients from roaming between access points.
To configure Ethernet protocol filtering, use the filter ethernet‐type filter enable command to
enable filtering and the filter ethernet‐type protocol <protocol> command to define the protocols
that you want to filter. To remove a protocol filter from the table, use the no filter ethernet‐type
protocol <protocol> command. To display the current settings, use the show filters command
from the Executive mode.
Example
RoamAbout 4102#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 4102(config)#filter wireless-ap-manage
RoamAbout 4102(config)#filter ethernet-type enable
RoamAbout 4102(config)#filter ethernet-type protocol CDP
RoamAbout 4102(config)#exit
RoamAbout 4102#show filters
Protocol Filter Information
===========================================================
IBSS Relay Control
802.11a VAP0 :ENABLED
Wireless AP Management :ENABLED
Ethernet Type Filter
Enabled Protocol Filters
-----------------------------------------------------------
Protocol: CDP
===========================================================
RoamAbout 4102#
:All VAP Mode
VAP1 :ENABLED
VAP2 :ENABLED
VAP3 :ENABLED
VAP4 :ENABLED
VAP5 :ENABLED
VAP6 :ENABLED
VAP7 :ENABLED
:ENABLED
RoamAbout RBT-4102 Wireless Access Point Configuration Guide 4-21
802.11b/g VAP0 :ENABLED
VAP1 :ENABLED
VAP2 :ENABLED
VAP3 :ENABLED
VAP4 :ENABLED
VAP5 :ENABLED
VAP6 :ENABLED
VAP7 :ENABLED
ISO: 0x2000
Filter Control and VLANs