Enterasys RoamAbout RBT-4102 Configuration Manual page 38

Overview
Table 4-1 Advanced Configuration (continued)
Menu
SNMP
Administration
System Log
WDS & STP
802.11a Interface
Radio Settings
802.11b/g Interface
Radio Settings
Status
4-2 Advanced Configuration
Description
Controls access to this access point from management stations
using SNMP, as well as the hosts that will receive trap messages.
Configures user name and password for management access;
upgrades software from local file, FTP, or TFTP server; resets
configuration settings to factory defaults; and resets the access
point.
Controls logging of error messages; sets the system clock via
SNTP server or manual configuration.
Configures bridge mode for each radio interface, and sets spanning
tree parameters.
Configures the IEEE 802.11a interface.
Configures radio signal parameters, and service set parameters for
the default interface and up to seven Virtual Access Points (VAPs).
Security Configures 802.1x client authentication, with an option for MAC
address authentication, and data encryption with Wired Equivalent
Protection (WEP) or Wi-Fi Protected Access (WPA).
Configures the IEEE 802.11b/g interface.
Configures radio signal parameters, and service set parameters for
the default interface, Wi-Fi Multimedia (WMM), and up to seven
Virtual Access Points (VAPs).
Security Configures 802.1x client authentication, with an option for MAC
address authentication, and data encryption with Wired Equivalent
Protection (WEP) or Wi-Fi Protected Access (WPA).
Displays AP status, CDP status, station status, Neighbor AP
Detection status, WDS-STP status, and event logs.
Page
4-29
4-38
4-44
4-49
4-55
4-55
4-74
4-55
4-55
4-74
4-94