Initial Setup Using the CLI
c.
d. Specify the new password again in the Confirm Password field.
e.
f.
7.
To specify the management VLAN ID:
a.
b. Click the Management VLAN ID: field and enter the VLAN ID from which you will
c.
8.
Go to Chapter
3-10 Initial Configuration
Specify a new password in the Password field.
Click Apply at the bottom of the page.
The access point displays a Settings Saved message.
Click OK.
Click Filter Control from the menu.
The Filter Control page appears.
manage the AP.
The management VLAN is for managing the access point. For example, the access point
allows traffic that is tagged with the specified VLAN to manage the access point via
remote management, SSH, SNMP, Telnet, and so forth. VLAN management is enabled by
default, and cannot be disabled.
Note: You must set up the network switch port to support tagged VLAN packets from the
access point. The switch port must also be configured to accept the access point's
management VLAN ID and native VLAN IDs.
Click Apply at the bottom of the page.
4 for advanced configuration.