Physical Connections - Vga Models - Hatteland JH 10T06 MMD User Manual

Physical Connections - VGA Models

Cable Tie Clamp
TOUCHSCREEN: (optional)
Connect the RS-232 cable to the D-SUB 9P Connector (female) on the rear side of the TFT display.
Connect the other end to your COM port of your computer. Install the nesscessary software needed to
operate it.
- Note that the connector is only installed upon customer request.
SIGNAL INPUT (RGB):
Connect the VGA cable to the D-SUB 15P Connector (female) on the rear side of the TFT display.
If possible, screw the VGA cable to the D-SUB connector and make sure you don't bend any of the pins
inside the VGA cable connector. To reduce tension of the VGA cable, secure it to the base mounted cable
tie clamp. Connect the other end of the cable to the VGA output of your computer, and fasten it there also.
POWER INPUT: (DC Version)
Secure the cables (check polarity!) to the screw terminal, you may secure the cable further by mounting it
to the base mounted cable tie clamp. The internal DC power module supports voltage from 12 to 24 VDC.
Rear side of display
Signal Input
640x480
VGA
POWER 12-24VDC 20W
- +
Power Terminal
80
Signal Input
Touchscreen (opt)
IND100132-10 Rev 1