Physical Connections - Hatteland HD 12T21 STD-xxx-Fxxx User Manual

Physical Connections

Note: 19 inch unit used as example above, please review specifications for your actual model.
Reduce Cable Tension
To reduce tension of the cables you connect, secure them with
a cable tie to the available chassis hinges located near the
connectors.
Note: Amount of chassis hinges can vary depending on model.
Connect a TYPE B USB Cable between this connector and your PC. Suitable drivers to install and calibrate the
touchscreen are available on the separate installation media delivered with the unit. Port is USB2.0 (<5m).
The COM (non-isolated RS-422/485) allows functionality to communicate with serial based equipment including
external buzzer functionality. Connect and fasten your cables from your compatible external equipment to the 5-pin
Terminal Block 3.81 connector. Please review the "Pinout Assignments" chapter as well as "Housing / Terminal Block
Connector Overview" in this manual for more information
Connect your DVI cable to the DVI-D 18+1P, Single Link Connector (female). Secure your DVI cable to the hex
spacers provided on the unit and make sure you do not bend any of the pins inside the connector. Connect the other
end of the cable to the DVI connector on your equipment and secure it.
IND100133-49
Connection area of unit (illustration)
USB Touch DVI-D In
RS-422/RS-485 COM
USB TOUCH:
RS-422 / RS-485 COM I/O:
DVI-D IN:
RS-232 COM
Power Input AC
VGA/RGB In
30
VGA/RGB Out
Power Input DC Grounding Screw