Physical Connections; Vga Signal, Power Terminal - Hatteland JH 21C07 MDK User Manual

PHYSICAL CONNECTIONS

Power Terminal
SIGNAL INPUTS:
There are two signal inputs connectors allowing you to display two signals from separate sources.
Connect the VGA cable to the desired D-SUB 15P Connector (female) on the rear side of the monitor.
If possible, screw the VGA cable to the D-SUB connector and make sure you don't bend any of the
pins inside the connector. Connect the other end of the cable to the VGA output of your computer, and
fasten it there also.
POWER TERMINAL
Make sure the monitor is turned off before connecting. Insert the powercable into the 220 VDC
power terminal.
Rear side of monitor
:
7
Product: JH 21C07MDK
Signal Inputs:
Input 1
Input 2
Product: JH 21C07MDK