Physical Connections - Mil Models - Hatteland JH 19T01 MIL User Manual

Physical Connections - MIL Models

Touchscreen (opt)
Composite Video In
(1 x BNC)
NOTE: There is no Composite Video In on JH 20T03 MIL model.
TOUCHSCREEN: (optional)
Connect the RS-232 cable to the D-SUB 9P Connector (female) on the rear side of the TFT display.
Connect the other end to your COM port of your computer. Install the nesscessary software needed to
operate it.
- Note that the connector is only installed upon customer request.
COMPOSITE VIDEO IN (PAL/NTSC/SECAM VIDEO):
Connect your composite video signal cable into the BNC plug. To activate the Picture In Picture function,
the TFT display must be configured via the OSD menus.
- Note that Composite Video must be selected as the incoming video source.
RGB IN: (RGBHV)
Connect the BNC cable to the 5 x BNC Connectors (female) on the rear side of the TFT display.
To reduce tension of the cables, secure it to the base mounted cable tie clamp. Connect the other end of
the cable to the VGA output of your computer, and fasten it there also.
POWER INPUT: (AC Version)
The internal AC power module supports both 115VAC/60Hz and 230/50Hz power input. You may secure
the cable further by mounting it to the base mounted cable tie clamp.
IND100133-6
Connection area of display (illustration)
RGB IN
(5 x BNC)
Power Input

INB100005-3 (Rev 9)
Remote Control(opt)