Physical Connections - Mmd/Std Models - Hatteland JH 10T06 MMD User Manual

Physical Connections - MMD/STD Models

VGA Out or Touch
(Optional)
Composite
S-Video
NOTE: Available connectors/locations may vary depending on model !
TOUCHSCREEN / VGA OUT: (optional)
Connect the RS-232 cable to the D-SUB 9P Connector (female) on the rear side of the TFT display.
Connect the other end to your COM port of your computer. Install the nesscessary software needed to
operate it.
- Note that the connector is only installed upon customer request. VGA OUT connector is then removed.
- By factory standards the product have been mounted with a VGA OUT 15PIN DSUB connector, this signal
is a clone of the incoming signal.
COMPOSITE (PAL VIDEO):
Connect your composite video signal cable into the RCA jack plug. To activate the Picture In Picture
function, the TFT display must be configured via the OSD menus.
- Note that Composite Video must be selected as the incoming video source.
S-VIDEO:
Connect your S-Video (SVHS) video signal cable into the mini 4-way din plug. It can only be inserted
one way and make sure you don't bend any of the pins inside your cable. To activate the Picture In Picture
function, the TFT display must be configured via the OSD menus.
- Note that S-Video must be selected as the incoming video source.
SIGNAL INPUT (RGB):
Connect the VGA cable to the D-SUB 15P Connector (female) on the rear side of the TFT display.
If possible, screw the VGA cable to the D-SUB connector and make sure you don't bend any of the pins
inside the VGA cable connector. To reduce tension of the VGA cable, secure it to the base mounted cable
tie clamp. Connect the other end of the cable to the VGA output of your computer, and fasten it there also.
Connection area of display (illustration)
Signal Input (RGB)
Power Input
DVI-D
21 IND100133-1 Rev 2
Led Adjust (older models)
Remote Control(opt)
continues....