Table of Contents
Advertisement
Physical Connections
Power Inputs DC & AC
Grounding Screw
Note: 24 inch unit used as example above, please review specifications for your actual model.
Reduce Cable Tension
To reduce tension of the cables you connect, secure them with
a cable tie to the available chassis hinges located near the
connectors. Note that the actual position of these hinges may
vary depending on the specific unit.
- +
Connect your DC power cable to the 2-pin Terminal Block 5.08 connector. The internal DC power module supports
24VDC. Please check specifications for your unit.
The internal AC power module supports both 115VAC/60Hz and 230VAC/50Hz power input. Please check
specifications for your unit.
Note: DC models are required / recommended to be properly grounded via the
review "General Installation Chapter", pt. 7 for more information.
Multi-power note: (For units supporting AC & DC input simultaneously)
The unit has a dual input power supply which will accept both AC and DC input. If both inputs are connected, the
unit will be powered by AC. If AC is disconnected it will automatically switch over to DC without affecting the operation
of the unit. This makes it possible to use AC power as primary power and a 24V battery as secondary power,
eliminating the need for expensive UPS systems.
IND100133-45
Connection area of unit (illustration)
PS/2 Keyboard & Mouse In
RGB/VGA Out
POWER INPUT:
POWER INPUT:
GROUNDING SCREW:
DVI-I/RGB Out
2 x RJ45 Network
RS-232 & RS-422/RS-485 COM
30
Mic In & Line Out
Expansion Area
for Optional Modules
USB 1,2,3,4
screw located on the unit. Please
2 x Removable
Storage Trays
Advertisement
Table of Contents
