Notes - Hatteland JH 10T06 MMD User Manual

Notes

- The monitor is type approved according EN60945 (1997), 4.4, equipment category b) protected
from the weather.
- Use of brightness and push buttons may inhibit visibility of information at night.
VGA BIOS Firmware: (On MMD and similar products only)
On older products you will ONLY have the advanced version of the OSD menu. (V0.x / 1.0 / 1.10)
On newer products you will ONLY have the simplified version of the OSD menu. (V1.2 and up)
To verify your BIOS Firmware version, the version number is displayed in the UTILITIES menu in
the right top corner. If no version number shows, you may have a BIOS Firmware below V1.00
This manual matches the BIOS Firmware V1.00 / V1.10 / V1.2 / V1.2F1 / V1.2F2 and V1.3F
As the available functions are nearly indentical between older products and V1.3F, there should
be no critical need to update the BIOS Firmware. In any case, consult your local technician or
sales/technical personnel at Hatteland Display if problems arise during the installation or within
usage of the product or lack of support for your signal refresh rate etc.
See also the "Revision Record xxx Controller" section in this manual for more detailed information
about VGA BIOS firmware revisions.
DVI-D Support:
During May 2003, new factory produced MMD and similar models will be upgraded with support
for DVI-D. This will include a new DVI-D 24pin connector in addition to the already installed con-
nections, like S-VHS, Composite and RGB connectors. DVI-D transmits the RGB signals digitally,
which gives sharper quality images and correct color presentation. Just connect the cable between
your computer system and our display. The VGA controller will automatically use the DVI-D as
output if configured to do so.
General 12 IND100077-1 Rev.2