Physical Connections - Hm Mil Models - Hatteland HM 20T07 MIL User Manual

Physical Connections - HM MIL Models

Composite Video In
(1 x BNC)
Connect your BNC cable connector (male) to the BNC Connectors (female) on the unit. This will allow a video signal
from i.e. cameras & dvd players to be visible on screen either as full screen video or Picture-In-Picture/Picture-By-Pic-
ture. To activate any of these functionalities, the unit must be configured via the OSD menus (see own chapter). PAL /
NTSC / SECAM VIDEO signal formats supported.
Connect your BNC cable to the 5 x BNC Connectors (female) connect the opposite to your equipment. Make sure the
connectors is firmly fasten and that you do not switch around the separate signal/colors for: R(to red color cable),
G(to green color cable), B(to blue color cable) H(to horizonal sync gray color cable) and V(to vertical sync black color
cable).
RGB OUT enables a direct clone of the incoming VGA (5 x BNC) signal. Connect the cable to the D-SUB 15P
Connector (female) and secure it to the hex spacers provided on the unit. Connect the other end to your equipment
and secure it.
This 9P COM connector provides touch screen communication for display units that have been equipped with a
factory mounted touch screen. It should be connected to a computer with touch screen drivers installed. See the touch
screen chapter in this manual for more information.
- Note that the connector is only installed upon customer request, and it will occupy 1 x DSUB connector from the
Remote Control functionality (see next page)
IND100133-33
Connection area of display (illustration)
RGB IN
( 1 x 15DSUB)
(5 x BNC)
COMPOSITE VIDEO IN (PAL/NTSC/SECAM VIDEO):
RGB IN: (RGBHV - Circular BNC connectors)
RGB OUT:
TOUCHSCREEN: (optional)
RGB OUT
Touchscreen (option)
18
Power Input
Remote Control
1 or 2 x 9PDSUB
INB100005-8 (Rev 5)