Physical Connections; Vga Signal, Power Terminal, Touchscreen Connector - Hatteland JH 21C06 User Manual

PHYSICAL CONNECTIONS

Power Terminal
SIGNAL INPUTS:
There are two signal inputs connectors allowing you to display two signals from separate sources.
Connect the VGA cable to the desired D-SUB 15P Connector (female) on the rear side of the monitor. If
possible, screw the VGA cable to the D-SUB connector and make sure you don't bend any of the pins inside
the connector. To reduce tension of the VGA cable, secure it to the base mounted cable tie clamp. Connect
the other end of the cable to the VGA output of your computer, and fasten it there also.
POWER TERMINAL
Make sure the monitor is turned off before connecting. Insert the powercable into the 220 VDC
power terminal. You may secure the cable further by mounting it to the base mounted cable tie clamp.
TOUCHSCREEN: (optional)
Connect the RS-232 cable to the D-SUB 9P Connector (female) on the rear side of the monitor.
Connect the other end to your COM port of your computer. Install the nesscessary software needed to
operate it.
Rear side of monitor
WARNING
POWER
TO PREVENT ELECTRIC CHOCK,
DO NOT REMOVE BACK.
NO USER-SERVICEABLE
PARTS INSIDE
XXXXT3A1
INPUT 2
:
7
Product: JH 21C06
Touch screen (opt)
Signal Inputs:
INPUT Input 1
Input 2
Product: JH 21C06