Hatteland JH 10T06 MMD User Manual page 22

Physical Connections - MMD/STD Models
DVI-D INPUT: (Only on models produced after/during May 2003)
Connect the DVI cable to the DVI-D 24P Connector (female) on the rear side of the TFT display.
If possible, screw the DVI cable to the DVI-D connector and make sure you don't bend any of the pins
inside the DVI cable connector. To reduce tension of the DVI cable, secure it to the base mounted cable tie
clamp. Connect the other end of the cable to the DVI-D output of your computer, and fasten it there also.
POWER INPUT: (AC Version)
The internal AC power module supports both 115VAC/60Hz and 230/50Hz power input. You may secure
the cable further by mounting it to the base mounted cable tie clamp.
POWER INPUT: (DC Version)
Secure the cables (check polarity!) to the screw terminal, you may secure the cable further by mounting it
to the base mounted cable tie clamp. The internal DC power module supports voltage from 12 to 24 VDC.
REMOTE CONTROL: (optional)
The two serial remote control connectors are used for displays with the JHSCOM-A1 or JHSCOM-B1.
It features a RS232/RS422/RS485 interface for controlling all parameters, including brightness, for the
display. For further information, see the "Remote Control Specification" at www.hatteland.com
LED ADJUST: (Only on older versions)
The led adjust is only present in displays descibed in the chapter automatic power light dimming. With the
led adjust knob, you can manually adjust the intensity of the power light indicator which is located in the
front of the display. The power light indicator is controlled by the Auto Power LED Dimming function which
automatically adjusts the intensity of the power light based on your environment lightning. You could also
turn it off if that is necessary.
Note:
If you have optional accessories beyond these standard connectors described here, you are welcome to
visit our website at www.hatteland.com for separate documentation/specifications regarding accessories
(when made available).
22 IND100133-1 Rev 2