Physical Connections - Mmd Backpack Series 2 - Hatteland HD 12T04 series User Manual

Physical Connections - MMD Backpack Series 2

DVI-I IN
RGB IN
Composite Video IN
Connect the DVI cable to the DVI-I 24+5P Connector (female) on the rear side of the TFT display.
Screw the DVI cable to the connector spacers and make sure you don't bend any of the pins
inside the DVI cable connector. Connect the other end to your computer equipment.
This DVI-I connector can also be converted to function as RGB IN by using the provided
DVI<>RGB adapter plug.
Connect the VGA cable to this D-SUB 15P Connector (female) on the rear side of the TFT display.
Screw the VGA cable to the D-SUB connector spacers and make sure you don't bend any of the
pins inside the VGA cable connector. Connect the other end to your computer equipment.
Connect your composite video signal cable into this RCA jack plug. To activate the Picture In
Picture function, the TFT display must be configured via the OSD menus.
- Note that Composite Video must be selected as the incoming video source in the OSD menu.
Connect your S-Video (SVHS) video signal cable into this mini 4-way din plug. It can only be
inserted one way and make sure you don't bend any of the pins inside your cable. To activate the
Picture In Picture function, the TFT display must be configured via the OSD menus.
- Note that S-Video must be selected as the incoming video source in the OSD menu.
This USB TYPE B connector is used as a loopthrough from the front connector on a Series 2
TFT compatible display. It allows you to connect peripherals in the front of your display unit
and connect them further to your computer equipment. The signal is transferred without any
conversion and is a direct 1-1 cable connection.
Operation
IND100133-17
Connection area of backpack (illustration)
S-Video IN
DVI-I IN / RGB2 IN: (Supports both DVI & Analog RGB)
RGB1 IN:
COMPOSITE IN (PAL/NTSC/SECAM VIDEO):
S-VIDEO IN:
USB OUT:
COM1
USB OUT

INB100026-1 (Rev 9)
COM2 Power Input
Area