Configuring (Enabling Or Disabling) The Timep Mode - HP PROCURVE 2520 Management And Configuration Manual

Time Protocols
TimeP: Viewing, Selecting, and Configuring
ProCurve(config)# show management
Status and Counters - Management Address Information
Time Server Address : 10.10.28.100
Priority SNTP Server Address
-------- ---------------------------------------------- ----------------
1 10.10..28.101
2 10.255.5.24
3 fe80::123%vlan10
Default Gateway
VLAN Name MAC Address
------------ ------------------- + -------------------
DEFAULT_VLAN 001279-88a100
VLAN10 001279-88a100
Figure 9-15. Example of Display Showing IP Addressing for All Configured Time Servers and VLANs

Configuring (Enabling or Disabling) the TimeP Mode

Enabling the TimeP mode means to configure it for either broadcast or unicast
mode. Remember that to run TimeP as the switch's time synchronization
protocol, you must also select TimeP as the time synchronization method by
using the CLI timesync command (or the Menu interface Time Sync Method
parameter).
Syntax: timesync timep
Syntax: ip timep < dhcp | manual >
Syntax: no ip timep
Syntax: no timesync
9-20
: 10.0.9.80
| IP Address
| 10.30.248.184
| 10.0.10.17
Selects TimeP as the time protocol.
Enables the selected TimeP mode.
Disables the TimeP mode.
Disables the time protocol.
Protocol Version
3
3
3