HP PROCURVE 2520 Management And Configuration Manual page 222

Port Status and Configuration
Viewing Port Status and Configuring Port Parameters
ProCurve(config)# show int custom 1-4 port name:4 type vlan intrusion speed
enabled mdi
Status and Counters - Custom Port Status
Port Name
---- ---------- ---------- ----- --------- ------- ------- --------
1 Acco
2 Huma
3 Deve
4 Lab1
Figure 10-6. Example of the Custom show interfaces Command
You can specify the column width by entering a colon after the column name,
then indicating the number of characters to display. In Figure 10-6 the Name
column only displays the first four characters of the name. All remaining
characters are truncated.
10-12
Parameter Column Displays
port Port identifier
type Port type
status Port status
speed Connection speed and duplex
mode Configured mode
mdi MDI mode
flow Flow control
name Friendly port name
vlanid The vlan id this port belongs to, 4
or "tagged" if it belongs to more tagged
than one vlan
enabled port is or is not enabled
intrusion Intrusion alert status
bcast Broadcast limit
Intrusion
Type VLAN Alert
10/100T 1 No
10/100T 1 No
10/100T 1 No
10/100T 1 No
Examples
A2
100/1000T
up or down
1000FDX
auto, auto-100, 100FDX
auto, MDIX
on or off
yes or no
intrusion
no
0
Speed Enabled MDI-mode
100FDx Yes Auto
100FDx Yes Auto
100FDx Yes Auto
100FDx Yes Auto