HP PROCURVE 2520 Management And Configuration Manual page 77

Syntax: repeat [cmdlist] [count] [delay]
For example:
ProCurve(config)# show history
3 show ver
2 show ip
1 show arp
ProCurve(config)# repeat 1-2
IP ARP table
IP Address
---------------
15.255.128.1
Internet (IP) Service
Default Gateway :
Default TTL
Arp Age
Domain Suffix
DNS server
VLAN
-------------------- + ---------- --------------- --------------- ---------
DEFAULT_VLAN
Figure 4-11. Example of repeat Command Using a Range
Repeats execution of a previous command. Repeats the last
command by default until a key is pressed.
cmdlist: If a number or range of numbers is specified, the
command repeats the n
is the position in the history list).
count: Repeats the command for the number of times specified.
delay: The command repeats execution after a delay for the
number of seconds specified.
ProCurve(config)# repeat 1-4,7-8,10 count 2 delay 3
Repeats the show arp and show ip commands.
MAC Address Type
----------------- ------- ----
000000-000000 dynamic
: 64
: 20
:
:
| IP Config IP Address
| DHCP/Bootp 15.255.131.90
Using the Command Line Interface (CLI)
CLI Control and Editing
th
most recent commands (where "n"
Port
Subnet Mask
255.255.248.0
Proxy ARP
No No
4-17