At this point, press
[Enter] and start the
Xmodem command
sequence in your
terminal emulator.
Figure A-11. Example of Sending Command Output to a File on an Attached PC
N o t e
The command you specify must be enclosed in double-quote marks.
Copying Event Log Output to a Destination Device
Syntax: copy event-log tftp < ip-address > < filepath_filename >
For example, to copy the event log to a PC connected to the switch:
At this point, press
[Enter] and start the
Xmodem command
sequence in your
terminal emulator.
Figure A-12. Example of Sending Event Log Content to a File on an Attached PC
Copying Crash Data Content to a Destination Device
This command uses TFTP or Xmodem to copy the Crash Data content to a
destination device. You can copy individual slot information or the manage
ment module's switch information. If you do not specify either, the command
defaults to the management function's data.
Copying Diagnostic Data to a Remote Host, PC or UNIX Workstation
copy event-log xmodem <filename>
These commands copy the Event Log content to a remote host
or to a serially connected PC or UNIX workstation.
File Transfers
Indicates the operation is finished.
A-29