HP PROCURVE 2520 Management And Configuration Manual page 343

For example, if port 3 belongs to a subnetted VLAN that includes an IP address
of 10.10.10.100 and you wanted port 3 to use this secondary address in LLDP
advertisements, you would need to execute the following command:
ProCurve(config)# lldp config 3 ipAddrEnable 10.10.10.100
Optional Data. You can configure an individual port or group of ports to
exclude one or more of these data types from outbound LLDP advertisements.
Note that optional data types, when enabled, are populated with data internal
to the switch; that is, you cannot use LLDP commands to configure their actual
content.
■ port description (TLV)
system name (TLV)
■
■ system description (TLV)
■ system capabilities (TLV)
• system capabilities Supported (TLV subelement)
• system capabilities Enabled (TLV subelement)
■ port speed and duplex (TLV subelement)
Syntax: [ no ] lldp config < port-list > basicTlvEnable <
port_descr
For outbound LLDP advertisements, this TLV includes an
alphanumeric string describing the port.
(Default: Enabled)
system_name
For outbound LLDP advertisements, this TLV includes an
alphanumeric string showing the system's assigned
name.
(Default: Enabled)
system_descr
For outbound LLDP advertisements, this TLV includes an
alphanumeric string describing the full name and version
identification for the system's hardware type, software
version, and networking application.
(Default: Enabled)
Configuring for Network Management Applications
LLDP (Link-Layer Discovery Protocol)
TLV-Type >
13-51