Set Switch Ip Address Dialog Box: New Switch Setup; First Step Of New Switch Setup Completed - HP StorageWorks SN6000 - Fibre Channel Switch User Manual

5. Choose one of the following options:
• To continue with the first step (setting the switch IP address), click OK. The Set Switch IP Address
dialog box (Figure
• To skip the switch setup for now, click Cancel. (To set up the switch later, see the procedures in
"Managing switches"
Connection Manager, the New Switch Setup dialog box will open again the next time you start the
application.)
The Set Switch IP Address dialog box
Figure 13

Set Switch IP Address dialog box: new switch setup

6. Select either the Enable IPv4 or Enable IPv6 check box, and then complete the appropriate IPv4 or IPv6
information (for details, see
The New Switch Setup dialog box now shows a check mark next to the first step, "Set switch IP
address," (Figure 14) indicating that you have completed that task.
Figure 14

First step of New Switch Setup completed

7. A message box asks if you want to change the factory default switch administrator password. Choose
one of the following options:
• To continue with the next step of switch setup, click Yes. The Set Switch Admin Password dialog box
(Figure 15) opens. Go to
• To change the default password later, click No. (See
for a procedure for changing the switch admin password—either the default or the current
password—to a new password.)
13) opens. Go to step 6.
on page 51. If you do not complete switch set up before you exit Simple SAN
(Figure 13) shows the switch name and default IP address.
"Setting the switch IP address"
step 8.
HP StorageWorks Simple SAN Connection Manager User Guide
on page 57). Click OK.
"Setting the switch admin password," page 57,
39