HP PROCURVE 2520 Management And Configuration Manual page 237

Syntax: show interface < port-number >
For example, if you configure port 5 with the name "O'Connor_10.25.101.43",
the show interface output for this port appears similar to the following:
ProCurve(config)# show int 5
Status and Counters - Port Counters for port 5
Name : O'Connor@10.25.101.43
Name :
MAC Address
Link Status
Totals (Since boot or last clear) :
Bytes Rx
Unicast Rx
Bcast/Mcast Rx
Errors (Since boot or last clear) :
FCS Rx
Alignment Rx
Runts Rx
Giants Rx
Total Rx Errors : 0
Others (Since boot or last clear) :
Discard Rx
Unknown Protos
Rates (5 minute weighted average) :
Total Rx (bps) : 0
Unicast Rx (Pkts/sec) : 0
B/Mcast Rx (Pkts/sec) : 0
Utilization Rx
Figure 10-18. Example of a Friendly Port Name in a Per-Port Statistics Listing
For a given port, if a friendly port name does not exist in the running-config
file, the Name line in the above command output appears as:
To Search the Configuration for Ports with Friendly Port Names.
This option tells you which friendly port names have been saved to the startup­
config file. (show config does not include ports that have only default settings
in the startup-config file.)
Includes the friendly port name with the port's traffic statistics
listing.
: 001ffe-74b3fb
: Down
: 0
: 0
: 0
: 0
: 0
: 0
: 0
: 0
: 0
: 0 %
Name : not assigned
Using Friendly (Optional) Port Names
Friendly Port
Name
Bytes Tx : 0
Unicast Tx : 0
Bcast/Mcast Tx : 0
Drops Rx : 0
Collisions Tx : 0
Late Colln Tx : 0
Excessive Colln : 0
Deferred Tx : 0
Out Queue Len : 0
Total Tx (bps) : 0
Unicast Tx (Pkts/sec) : 0
B/Mcast Tx (Pkts/sec) : 0
Utilization Tx :
Port Status and Configuration
0 %
10-27