Displaying A Debug/Syslog Configuration - HP PROCURVE 2520 Management And Configuration Manual

Troubleshooting
Debug/Syslog Operation
5. If you configure system-module and/or severity-level values to filter Event
ProCurve(config)# no logging severity < debug | major | error | warning | info>
ProCurve(config)# no logging system-module < system-module >
C a u t i o n
If you configure a severity-level, system-module, logging destination, or
logging facility value and save the settings to the startup configuration (for
example, by entering the write memory command), the debug settings are
saved after a system reboot (power cycle or reboot) and re-activated on the
switch. As a result, after switch startup, one of the following situations may
occur:
■
■

Displaying a Debug/Syslog Configuration

Use the show debug command to display the currently configured settings for:
■
■
Syntax: show debug
C-36
To display a list of valid values for each command, enter logging severity
or logging system-module followed by ? or pressing the Tab key.
The severity levels in order from the highest to lowest severity are: major,
error, warning, info, debug. For a list of valid values for the logging system-
module <system-module > command, refer to Table C-1 on page C-23.
Log messages, when you finish troubleshooting, you may want to reset
these values to their default settings so that the switch sends all Event Log
messages to configured debug destinations (Syslog servers and/or CLI
session).
To remove a configured setting and restore the default values that send
all Event Log messages, enter one or both of the following commands:
Only a partial set of Event Log messages may be sent to configured debug
destinations.
Messages may be sent to a previously configured Syslog server used in an
earlier debugging session.
Debug message types and Event Log message filters (severity level and
system module) sent to debug destinations
Debug destinations (Syslog servers or CLI session) and Syslog server
facility to be used
Displays the currently configured debug logging destinations
and message types selected for debugging purposes. (If no
Syslog server address is configured with the logging
addr command, no show debug command output is displayed.)
>
syslog-ip­
<