Cli: Viewing And Configuring Timep - HP PROCURVE 2520 Management And Configuration Manual

Time Protocols
TimeP: Viewing, Selecting, and Configuring
5. In the Poll Interval field, enter the time in minutes that you want for a
Press
time protocol configuration in both the startup-config and running-config
files.

CLI: Viewing and Configuring TimeP

CLI Commands Described in this Section
Command
show timep
[no] timesync
ip timep
no ip timep
This section describes how to use the CLI to view, enable, and configure TimeP
parameters.
9-18
ii. Enter the IP address of the TimeP server you want the switch to
use for time synchronization.
Note: This step replaces any previously configured TimeP server
IP address.
[>]
to move the cursor to the Poll Interval field, then go to
iii. Press
step 6.
TimeP Poll Interval.
to return to the Actions line, then [S] (for Save) to enter the new
[Enter]
9-20 ff., 9-23
dhcp
manual
server <ip-addr>
interval
Page
9-19
9-21
9-22
9-22
9-23
9-23